Removing And Replacing The Cover - HP Kayak XU03 User Manual

Removing and Replacing the Cover

The following procedures are valid for HP Kayak XA-s, XU Series 0301 and
0303, and XW Series U3 and W3 PC Workstations.
Removing the
Cover If necessary, unlock the cover. The lock and key for
the cover are at the back of the PC Workstation, just below
the rear panel connectors.
Replacing the
Cover
Ensure that the two latches on the front
sides of the cover are lifted up, and that the
lock is unlocked.
Removing and Replacing the Cover
Lift the two latches
on the front sides of the
computer upwards.
Slide the cover onto the computer, making sure
that the two guides at the bottom of the case slide
into the two rails at the base of the computer.
Firmly slide the cover backwards into position.
lock the cover
using the key.
8
Grasp the cover on the sides at the back of the
computer and slide it forwards and off the computer.
sides of the cover.
If required,
Lower the two latches on the front