Replacing The System Board - HP Kayak XM600 User Manual

Removing the
System Board

Replacing the System Board

1 Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2 Remove the PC Workstation's cover and front bezel (refer to page 23 for
these instructions).
3 Remove the HP UltraFlow Airflow Guide (refer to page 24 for
instructions).
4 Disconnect any cables attached to the system board.
5 Move the front access cage forward (described on page 37).
6 Remove the main memory, processor and any accessory cards from the
old system board (described in this chapter).
7 Remove the screw located on the rear panel near the AGP slot
8 Lift the system board out, being careful not to damage the PC's rear
connectors.
9 Unclip the retaining bracket from the system board. This bracket must
be re-installed on the new system board (refer to the diagram on the
following page).
ò
2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
.
47