Replacing the
Assembly
10 Lift the hard disk drive bay and speaker assembly upwards to remove it
from the computer.
1
Ensure that there are no cables underneath the hard disk drive bay and
speaker assembly.
2
Align the two plastic tabs (control panel side) of the hard disk drive bay
and speaker assembly with their associated notches.
3
Ensure that the plastic clips on the front of the hard disk drive bay and
speaker assembly are lined-up with their associated locations.
4
From the front of the PC, gently push towards you the right-hand side of
the hard disk drive bay and speaker assembly until it clicks in place.
Repeat this procedure on the left-hand side of the hard disk drive bay
and speaker assembly.
5
Reconnect the speaker and control panel cables to their connectors on
the system board.
6
Reconnect the data and power cables. Replace the hard disk drive and
hard disk drive tray.
7
Replace the PC Workstation's cover and front bezel (refer to page 23).
Reconnect all the power and telecommunications cables.
2 Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the Hard Disk Drive Bay and Speaker Assembly
Retention clip
43