HP Kayak XA-s02 Supplementary Manual page 3

Component
Microprocessor
Main Memory
Mass Storage
Graphics Controller
Accessory Board Slots
Communications
CD-ROM Drive
Audio
HP MaxLife Utility
(available on all models)
Power Supply
1.
The internal drive housing can support one 1" and one 1.6" high hard disk drive or two 1" hard disk drives.
HP Kayak XA-s Desktop PC Workstation Overview
All models have dual processor slots and are supplied with single or dual processors.
266, 300, 333, 350 or 400 MHz Pentium II processor with 512 KB cache memory and higher frequencies
when available.
Models are supplied with 32 MB or 64 MB of Non-ECC SDRAM
Three DIMM sockets upgradeable using:
256 MB Registered ECC SDRAM to a maximum of 768 MB, or
64 MB or 128 MB unbuffered ECC SDRAM, or 32 MB, 64 MB or 128 MB non-ECC to a maximum of 384 MB.
Registered ECC SDRAM memory modules cannot be mixed with Non-Buffered modules.
All models have 5 shelves: 3 front-access (1 X 3½-inch, 2 X 5¼-inch); 2 internal (3½-inch)
4.3 or 6.5 GB IDE (Ultra ATA/33)
or
4.5 GB SCSI
All models are equipped with a Matrox G100 AGP graphics controller board. There is 8 MB of installed video
memory (not upgradeable).
All models have 6 slots: 1 AGP, 3 PCI, 1 ISA, 1 combination ISA/PC.
1 PCI slot may be used (SCSI + LAN) and 1 AGP slot is used (graphics).
All models have 2 USB connectors, 2 serial ports, 1 parallel port and 4 sound connectors.
All models include a 32X speed IDE CD-ROM.
All models have an Integrated 16-bit hi-fi audio processor with music synthesizer and mixer
Hardware monitoring utility that monitors system components (for example: if you are unable to get the
system and display working properly). When an error is detected it is displayed on the dedicated LCD located
on the front panel.
Input voltage: 100-127, 200-240 Vac
Input frequency: 45/66 MHz
Maximum output power: 260 W continuous
HP Kayak XA-s Desktop PC Workstation Overview
XA-s
1
.
3