Power Limitation Menu - Smeg SI2631D Manual

using a wire that is at least 20 mm longer than
the other wires.
The appliance can work in the following modes:
380-415 V 3N~
5 x 1.5 mm ²
five-core cable
220-240 V 1N~
3 x 4 mm ²
three-core cable
The diagram below illustrates the terminal from
below, with no cables connected.
The values indicated refer to the cross-
section of the internal conductor.
The aforementioned power cables are
sized taking into account the
coincidence factor (in compliance with
standard EN 60335-2-6).
Use the supplied jumper for each
connection, if any
Fixed connection
Fit the power line with an all-pole circuit breaker
with a contact separation distance sufficient to
provide complete disconnection in category III
overvoltage conditions, pursuant to installation
regulations.
For the Australian/New Zealand market:
The circuit breaker incorporated in the fixed
connection must comply with AS/NZS 3000.

Power limitation menu

• Access to this menu is restricted to
the installer.
• The appliance is factory set to a
maximum power of 7.2 kW.
High power regime
The following procedure allows you to access
91477A308/A
the menu in order to modify the power supplied
by the appliance. Values between 7.2 and 2.8
kW can be selected:
1. Switch off all the plates before proceeding.
2. Disconnect the appliance from the mains
power supply.
3. Reconnect the appliance to the mains
power supply.
Carry out the following procedure within 30
seconds of the appliance being reconnected:
4. Press and hold the
controls.
5. Press the following combination of buttons:
A beep will be emitted and the current power
level will be shown on the display: "72",
corresponds to 7.2 kW.
6. Use the and
value of the available options.
• To save the changes, enter the same key
combination used to access the menu. The
appliance will switch off and you will have
to switch it on again in order to use it with the
new power setting.
• If you do not wish to save the changes,
simply do not use the display for at least 60
seconds, until it switches off.
Low power regime
1. Follow the instructions described above as
far as point 4.
2. Press the and
menu.
A beep will be emitted and "28",
corresponding to 2.8 kW, will appear on the
display.
3. Use the and
value of the available options.
• Press the and
time to save the changes. The appliance will
switch off and you will have to switch it on
again in order to use it with the new power
setting.
• If you do not wish to save the changes,
button to unlock the
buttons to change the
buttons to access the
buttons to change the
buttons at the same
INSTALLATION - 31