Section Cut From The Countertop - Smeg SI2631D Manual

simply do not use the display for at least 60
seconds, until it switches off.
High power regime
Power shown on display
Low power regime
Power shown on display

Section cut from the countertop

Safety instructions for positioning and
installation
See General safety instructions.
• Installation can be carried out on various
materials such as masonry, metal, solid
wood or plastic laminated wood as long as
they are heat resistant (>90°C).
• Veneers, adhesives or plastic coatings on
adjacent furniture should be temperature-
resistant (>90°C), otherwise they might
warp over time.
• If the piece of furniture does not have the
required recess opening, either it will have
to be cut or masonry work carried out by a
competent technician.
• The minimum clearance between exhaust
hoods and the cooking surface must be at
least the distance indicated in the exhaust
hood installation instructions.
• The minimum clearances must also be
respected for the edges of the hob on the
back as indicated in the assembly
instructions.
• If the appliance is to be installed above an
32 - INSTALLATION
Power in kW
7.2 - default value
6.0
3.4
2.8
Power in kW
2.8 - default value
2.2
1.6
1.0
oven, the oven must be fitted with a cooling
fan.
Appliance overall dimensions (mm)
L 600
Built-in cabinet dimensions (mm)
A min. 50
B min. 460
C min. 750
D 30 - 50
E min. 50
L min. 600
Hob seal
To prevent leakage of liquid between the frame
of the hob and the countertop, place the
adhesive seal provided along the entire outer
edge of the hob before assembly.
Do not use silicone to secure the hob.
This would make it impossible to remove
the hob without damaging it.
In the case of flush mounting, after placing the
adhesive seal (A) on the glass surface and after
positioning and securing the hob, fill the edges
91477A308/A