Fcc Statement; Fcc Compliance - HP Compaq t1010 User Manual

FCC Statement

This equipment has been tested and found to comply with the limits for either Class
A or Class B digital devices (refer to "Terminal Requirements Compliance"),
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution
Changes or modifications not covered in this manual
must be approved in writing by the manufacturer's
Regulatory Engineering department. Changes or
modifications made without written approval may void
the user's authority to operate the equipment.
Terminal Requirements Compliance

FCC Compliance

The T1010 terminal meets Class B requirements.
IEC/EN Compliance
The T1010 terminal meets Class B requirements.
Canadian DOC Notices
Refer to the previous section, "Terminal Requirements Compliance," to find out
what model terminal each of the statements below refers to.
xii