Table of Contents
Advertisement
INSTRUCTIONS
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the top of the
unit. Use a screwdriver to loosen the screw
and then open the battery cover.
3. If used batteries are present, remove these
batteries from the unit by pulling up on one
end of each battery.
4. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•
Only batteries of the same or equivalent type as recommended
are to be used.
•
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
of
children.
6
Advertisement
Table of Contents
