Canon imageFORMULA DR-X10C User Manual page 65

Hint
Feeding a document longer the maximum detectable page size
for Auto Detection causes a paper jam indication, and transport
stops.
■ Continuous Manual Feeding Mode Setting
This mode disables automatic feeding by the pickup roller,
so that the loaded document stack must be fed by hand one
sheet at a time by the operator.
Feeding Mode" on p. 3-13.)
ON: The pickup roller is disabled.
OFF: Documents are fed by the pickup roller.
■ Stand-by Mode Setting
Selects the amount of time (240, 60 or 10 minutes) from
when the scanner is last used to when the Stand-by mode
is activated.
■ Display Language Setting
Selects Japanese or English for the language to display on
the control panel.
ON: Japanese display panel
OFF: English display panel
■ Display Contrast Adjustment
Use to adjust display panel contrast.
(See "Continuous Manual
4-12
■ SCSI Speed Setting
Selects the scanner's SCSI transfer speed.
If the scanner does not operate normally with the default
[20] (20 MBytes/s) speed, change this setting to reduce the
speed to [10] (10 MBytes/s) or [5] (MBytes/s).
■ USB Short Packet Setting
If the scanner does not operate normally when using the
USB interface, change this setting to [OFF].
■ Dust Detect Mode Setting
If dust is detected on the scanner glass when the scanner is
turned ON, the sensor position is moved forward or
backward to avoid vertical streaks caused by the dust on
the scanned image.
ON2: Displays an error message and stops scanning.
(scanning disabled)
ON: Normal display alternates with error message.
(scanning enabled)
OFF: Dust detection is disabled.
IMPORTANT
When the dust detection error message is displayed (either
continuously or alternating with the normal display), clean
the scanning glass.
Chapter 4 Other Functions