Canon imageFORMULA DR-X10C User Manual page 128

[Setting] Button
This button is enabled when [Automatic Feeding] is
selected, and allows you to set the delay time from when a
loaded document is detected until scanning starts.
Batch Separation
Items available for selection depend on the Feeding Option
setting: select batch separation timing (for when to start
scanning) according to the batch separation capabilities
provided by the application program.
[Standard Feeding] feeding option, batch separation is not
available
[Manual Feeding] Feeding Option
[Panel-Feeding] or [Automatic Feeding] Feeding Option
[Auto]
Each batch of documents is saved with different file
names.
[Panel]
A batch is separated when you press the [New File] key on
the control panel to start or continue scanning.
Chapter 8 ISIS/TWAIN Driver Settings
Batch Separation (when a patchcode decoder is
installed)
When the optional patchcode decoder is installed, batch
separation by patchcode is enabled for all feeding option
settings.
[Standard Feeding] Feeding Option
[Manual Feeding] Feeding Option
[Panel-Feeding] or [Automatic Feeding] Feeding Option
[Patchcode]
Batches are separated whenever a patchcode sheet is
detected between documents.
Sheets (Option)" on p. 3-19.)
IMPORTANT
• When [Patchcode] is selected, the [Folio] Scanning Side
setting on the [Basic] tab sheet is not available.
• When Multi-Stream is enabled in the application program,
[Patchcode] is not displayed.
8-20
(See "Using Patchcode