Option Specifications; Barcode Specifications - Canon imageFORMULA DR-X10C User Manual

2.

Option Specifications

This section contains the specifications for the separately sold Barcode Module
Sheets (Option)" (p. 3-19) for the specifications of the patchcodes that can be detected by the patchcode decoder.

Barcode Specifications

The following barcodes can be read by installing the optional
barcode module.
■ Barcode Types
Code No. of Digits
EAN 8 or 13
Codabar 3 to 32 (including
Start/Stop characters)
Code 39 3 to 32 (including
Start/Stop characters)
(Standard ASCII or
Full ASCII)
ITF 2 to 32 (Even
number. of digits
only)
Code 128 1 to 32 (Valid data
only)
UPC-A 13
UPC-E 8
Note: EAN, UPC-A and UPC-E add-ons supported
■ Detection Conditions
Checksum
Modulus 10, Weight 3
Modulus 16, 7 DR
Modulus 43
Modulus 10, Weight 3
Modulus 103
Modulus 10, Weight 3
Modulus 10, Weight 3
7-6
(p. 7-4) and imprinters. Refer to
Item Condition
Printed Front or back (or both, but at reduced speed)
Side
Orientation Perpendicular (0 degrees) or parallel (90
degrees) to the feeding direction
Feeding 0 degrees
Direction
Reading direction should be specified
beforehand
Note: Speed is slow when both directions are
specified.
Size Line Width 0.012" to 0.039" (0.3 to 1
mm)
When module width exceeds
0.021" (0.508 mm), Code
128, UPC-A, UPC-E and
EAN detect incorrectly
Code Width 4.134" (105 mm) or less
(including quiet zone)
Bar Height At least 0.393" (10 mm)
Margins At least one character at each
end
Slew Within ±3º
Element 2.2 to 3.0
Ratio
PCS Value At least 0.60 (with a white point of at least
75% reflectance)
Chapter 7 Appendix
"Using Patchcode
90 degrees