Turning the Power On/Off
Follow the procedures described below when turning the power on and off.
Turning the Power On
1.
Turn on the scanner.
The power switch is located on the lower right rear corner of the scanner.
To turn the scanner on, slide the power switch towards the " |" mark. When
the power indicator lights green, the scanner is on.
2.
Turn on the PC.
WARNING
If the unit ever makes a strange noise, emits smoke or a strange
odor, or becomes hot, or if the unit does not operate at all even
though the power is on, immediately turn the unit off and unplug
the power cord. Contact your dealer or service representative to
have the unit serviced.
Recognizing the Scanner
If you are using Windows 95/98/Me/2000 or Windows XP, then the first time
that you turn on your PC after connecting this scanner to your PC, Windows
Plug and Play automatically displays a screen prompting you to install the
scanner driver. Follow the instructions on the screen to proceed with the
installation.
If you are using Windows 95, the "Found New Hardware" dialog box
appears.
1. Select "Driver from disk provided by hardware manufacturer" and then
click the OK button.
2. Load the setup disc into your CD-ROM drive.
Installing the Scanner
29