Before Using the
Machine
1
Document and Paper
2
Copying
3
Sending and Receiving (MF6595cx/
MF6595/MF6590 Only)
4
Printing and
Scanning
5
Network (MF6595cx/MF6595/
MF6590/MF6540 Only)
6
Remote UI (MF6595cx/MF6595/
MF6590/MF6540 Only)
7
System Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
Fuser Roller
■
If black streaks appear with printing, the fuser roller in the main unit
may be dirty.
Should this occur, clean the fusing roller in the following procedure.
The roller should also be cleaned each time the toner cartridge is
replaced. Load a sheet of blank LTR paper into the multi-purpose
tray and start cleaning.
Cleaning the roller takes approximately 100 seconds.
1.
Press [Additional Functions].
2.
Press [
] or [
] to select <ADJUST./
CLEANING>, then press [OK].
3.
Open the multi-purpose tray.
Back
Previous
4.
Pull out the multi-purpose tray extension until it
clicks, then open it.
5.
Load a sheet of blank LTR paper.
6.
Press [
] or [
] to select <FIX. UNIT
CLEANING>, then press [OK].
Cleaning starts. When finished, the display returns to the standby
mode.
–
Use standard paper as the cleaning paper.
–
Throw away the cleaning paper after use.
TOP
Next
9-7