User Controls 用户控制装置 - PRESONUS Eris Sub8 Owner's Manual

Compact 8-inch studio subwoofer
Hide thumbs Also See for Eris Sub8:
Table of Contents

Advertisement

2
Hookup
2.2
HookupDiagrams
2.1.3
Power
2.1.4
User Controls 用户控制装置
IEC Power Connection. Your Eris Sub8 accepts a standard IEC power cord.
IEC 电源连接。你的Eris Sub8可以接受标准的IEC电源线。
Warning: Do not remove the center grounding prong or use a separate
ground-lift adapter, as this could result in electric shock.
警告:不要拔掉中间的接地线或使用单独的接地线适配器,因为
这可能导致电击。
PowerSwitch.This is the On/Off switch. The power status is indicatedby the
illuminated logo on the front of the cabinet.
PowerSwitch.(电源开关)这是一个开/关。电源状态由机柜正面的发光
标志来显示。
AC Select Switch. The input-power voltage is set at the factory to
correspondwith thecountry towhichit was shipped. Use this switch
only ifyou are using your Eris Sub8 in a country that uses a different
standard voltage than is used in the country where you purchased your
Sub8.
AC Select Switch.(开关)输入电源电压在出厂时就已经设置好了,
与运往的国家一致。只有当你的Eris Sub8在使用当地的电压标准与
你购买Sub8的国家不同时,才能使用此开关。
Polarity. The Polarity button reverses the polarity of the input signals.
Polarity. (极性)极性按钮可以颠倒输入信号的极性。
PowerUser Tip:Once your have connected your Sub8 to your system, try experimenting
with each setting while listening to your favorite music. Leave this switch in the position
where the bass was the loudest.
用户提示:一旦你把 Sub8 连接到你的系统上,在听最喜欢的音乐时,试验一
下每个设置。让这个开关处于低音最响的位置。
High Pass Filter. Removes frequency content below 80 Hz from the
full-range signalsent from the Sub8 outputs.This is useful if your
main studio monitors do not have their own high pass filter.
High Pass Filter. (高通滤波器)移除从Sub8输出的全频信号中低于
80Hz的频率内容。如果你的主监听设备没有自己的高通滤波器,这
就很有用。
Power User Tip: Leaving frequency content below 80 Hz in full-range monitors can
cancelout or reinforcethe highest frequencies that are reproducedby the Eris Sub8. This
can make the bass response of the overallsystem muddy and ill-defined. By rolling off
your full-rangespeakers,you will createa more linear frequency response between the
subwoofer andfull-range content.
用户提示:将 80Hz 以下的频率内容留在全音域监听中,可以抵消或加强 Eris
Sub8 所再现的最高频率。这可能使整个系统的低音响应变得浑浊和不明确。
通过衰减全频扬声器,你将在低音炮和全频内容之间创造一个更线性的频率
Eris
Sub8
Owner'sManual
5

Advertisement

Table of Contents
loading

Table of Contents