Note:
Please assemble with screws in the order shown in detail and tighten with same torque.
4. Service Hints
4.1. Service position for Main chassis
1. Remove the Rear Cover (Bottom) by removing (19) screws around
its perimeter.
2. Remove lead wires and bundles from holders as necessary.
3. Pull out main chassis and stand it.
4.2. Service Position for DG-Board
1. Remove the each circuit board from A or D-Board.
2. Connect extension cables between individual circuit board and A
or D-Board.
Note:
Extension cable kit is supplied as service fixtures and tools. (Part No. TZSC0724)
15