Table of Contents
Advertisement
8.7.1. Precautions in optical pickup replacement
The optical pickup can be damaged by static electricity from your body. Be sure to take static
electricity countermeasures when working around the optical pickup. (Refer to the related page
in this Manual about the countermeasures.)
1. Do not touch laser diode, actuator and their peripheries.
2. Do not use tester to check laser diode. (Laser diode can be
damaged easily.)
3. The use of soldering iron with anti-static feature is recommended
when providing short-circuit to laser diode or when removing it.
4. Solder the land on flexible cable of optical pickup unit.
Caution
- When using the soldering iron without anti-static feature, short-
circuit the flexible cable terminal with a clip before short-circuiting
the land.
- After intended repair is finished, remove the solder for short-circuit
of laser diode in a correct way by following the procedures
described in this Manual.
8.7.2. Disassembling the Optical Pickup Unit
1. Remove the 2 screws A and remove the TRV feed rack.
2. Remove the screw B and remove the Terminal FPC.
3. Remove the optical pickup.
42
Advertisement
Table of Contents
