Level Washer - Maytag MVWB750YW Installation Instructions Manual

4.
Connect inlet hoses to washer
Attach hot water hose to hot water inlet valve. Screw coupling
by hand until it is snug. Use pliers to tighten couplings an
additional two-thirds turn. Repeat with cold water inlet valve.
Both hoses must be connected for washer to work properly.
IMPORTANT:
Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
NOTE:
To reduce risk of hose failure, replace the hoses every
5 years. Record hose installation or replacement dates for
future reference.
Periodically inspect and replace hoses if bulges, kinks,
■
cuts, wear, or leaks are found.
5.
Check for leaks
Turn on water faucets to check for leaks from faucet and at
washer connection. A small amount of water may enter washer.
You will drain this in a later step.
6.
Secure drain hose
Laundry Tub Standpipe
4.5"
4.5"
(114 mm)
(114 mm)
A
A
Secure drain hose to laundry tub leg, drain standpipe, or
inlet hoses for wall standpipe with cable tie (A). This will help
reduce the chance of drain water splashing on the floor.

LEVEL WASHER

IMPORTANT:
noise and vibration.
Move the washer to its final location. Rock the washer back
and forth to check whether all four feet are stable and in firm
contact with the floor. If the washer rocks, minor adjustments
may be needed to level the washer on your floor.
Check the levelness of the washer. First, place a level
on the lid near the console. Then place the level on the side
of the washer in the crease between the top of the washer
Wall
and the cabinet.
4.5"
(114 mm)
A
Leveling your washer properly reduces excess
1.
Move washer to final location
2.
Check levelness of washer
Not Level LEVEL
Place level here
Place level
here
Not Level
7