file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0301000000.html
3.1 Replacement Procedure
TOP PREVIOUS NEXT
Removal
1. Remove the plastic chassis block according to steps 1 to 4 inclusive in the section "Removal of
A-P.C.Board".
2. Disconnect the CRT socket on the Y-P.C.Board.
3. Remove the anode cap from the picture tube.
4. Unscrew the 4 screws fixing the picture tube.
Installation
Install a new picture tube by the opposite procedure of the removal.
Adjustments Required
After replacing the picture tube, adjust every item in the chapter "Measurements and Adjustments".
•@
TOP PREVIOUS NEXT
file:///E:/BT-S1315DA_BT-S1315DAD_BT-S1415DA_BT-S1415DAD/SVC/s0301000000.html [2006-02-04 08:28:23]