Before You Call For Technical Support - HP Compaq dx2200 MT Quick Setup Manual

Getting Started
■
Remove all bootable media (diskette, CD, or USB device)
from the system before turning it on.
■
If you have installed an operating system other than the
factory-installed operating system, check to be sure that it is
supported on the system.
■
If the system has multiple video sources (embedded, PCI, or
PCI-Express adapters) installed (PCI-Express on some
models only) and a single monitor, the monitor must be
plugged into the monitor connector on the source selected as
the primary VGA adapter. During boot, the other monitor
connectors are disabled and if the monitor is connected into
these ports, the monitor will not function. You can select
which source will be the default VGA source in Computer
Setup.
Ä
CAUTION: When the computer is plugged into an AC power source,
there is always voltage applied to the system board. You must disconnect
the power cord from the power source before opening the computer to
prevent system board or component damage.

Before You Call for Technical Support

If you are having problems with the computer, try the appropriate
solutions below to try to isolate the exact problem before calling
for technical support.
■
Run the diagnostics utility (available for some models only).
Refer to the Troubleshooting Guide on the Documentation
CD for information on downloading the utility.
■
Run the Drive Protection System (DPS) Self-Test in
Computer Setup. Refer to the Computer Setup (F10) Utility
Guide on the Documentation CD for more information.
2-8 www.hp.com Quick Setup & Getting Started