Installing The Servomotor; Environmental Conditions; Vibration-Resistance Strength - Mitsubishi Electric MELDAS MDS-R Series Specifications And Instruction Manual

6-1 Installing the servomotor

CAUTION

6-1-1 Environmental conditions

Ambient temperature
Ambient humidity
Storage temperature
Storage humidity
Atmosphere
Altitude

6-1-2 Vibration-resistance strength

HF75, HF105
HF54, HF104, HF154, HF224, HF123,
HF223, HF142
HF204, HF354, HF303, HF302
Each vibration condition is as follows.
(µm)
Downloaded from ManualsNet.com
1. Do not hold the cables, shaft or detector when transporting the motor. Failure
to observe this could result in breakage and injury.
2. Securely fix the motor onto the machine. Improper fixing could cause the
motor to dislocate and result in injury.
3. Do not apply impact, such as by tapping with a hammer, when connecting the
coupling to the servomotor's shaft end. The detector could break.
4. Never touch the motor's rotating sections during operation. Provide a cover,
etc., on the shaft.
5. Do not apply a load exceeding the tolerable load on the servomotor shaft.
Failure to observe this could result in shaft breakage and injury.
6. Do not connect or disconnect any connector while the power is ON.
Environment
Motor type
200
100
80
60
50
40
30
20
0 1000 2000
Rotation speed (r/min)
search engine
6. Installation
Conditions
0°C to +40°C (with no freezing)
80%RH or less (with no dew condensation)
–15°C to +70°C (with no freezing)
90%RH or less (with no dew condensation)
Indoors (Where unit is not subject to direct sunlight)
No corrosive gases, inflammable gases, oil mist or dust
Operation/storage: 1,000m or less above sea level
Transportation: 10,000m or less above sea level
Acceleration direction
Shaft direction (X)
49m/s2 (5G) or less
24.5m/s2 (2.5G) or less
24.5m/s2 (2.5G) or less
X
3000
6 - 2
Direction of right
angle to the shaft (Y)
49m/s2 (5G) or less
24.5m/s2 (2.5G) or less
49m/s2 (5G) or less
Servomotor
Y
Acceleration