Solving Hardware Installation Problems - HP Compaq dc7600 USDT Getting Started Manual

Solving Hardware Installation Problems

You may need to reconfigure the computer when you add or
remove hardware, such as an additional drive or expansion card.
If you install a plug and play device, Windows XP automatically
recognize the device and configure the computer. If you install a
non–plug and play device, you must reconfigure the computer
after completing installation of the new hardware. In Windows
XP, use the Add Hardware Wizard and follow the instructions
that appear on the screen.
Solving Hardware Installation Problems
Problem
A new device is not
recognized as part
of the system.
Getting Started
Cause
Device is not seated
or connected
properly.
Cable(s) of new
external device are
loose or power
cables are
unplugged.
Power switch of new
external device is not
turned on.
When the system
advised you of
changes to the
configuration, you
did not accept them.
www.hp.com
Solution
Ensure that the device is
properly and securely
connected and that pins in the
connector are not bent down.
Ensure that all cables are
properly and securely connected
and that pins in the cable or
connector are not bent down.
Turn off the computer, turn on
the external device, then turn on
the computer to integrate the
device with the computer
system.
Reboot the computer and follow
the instructions for accepting the
changes.
Getting Started
31