Zanussi ZWP 582 User Manual page 6

By selecting this function the water of the last
rinse is not emptied out to prevent the fabrics
from creasing.
No spin
By selecting this option, all spinning phases are
suppressed and replaced by a drain, so as not
to wrinkle the laundry. Recommended for ex-
tremely delicate fabrics.
At the end of the programme, if you have selec-
ted "Rinse hold"
"Spin" or "Drain" programme to finish the cycle
and empty the water.
Selecting options
You must select the different options after se-
lecting the programme and before pressing the
"Start/Pause" button (see "Washing pro-
grammes"). Press the desired button(s) : the
corresponding lights come on. If pressed again,
the lights go out. If one of the options is not
compatible with the selected programme, the
"Start/Pause" button flashes red.
"Prewash" option
The appliance runs a prewash at 30°C max.
"Super quick" option
The washing time will be reduced depending
on the programme selected.
"Extra rinse" option
The washing machine will add one or more rin-
ses during the cycle. This option is recommen-
ded for people with sensitive skin and in soft
water areas.
"Delay start"
This option allows you to delay the start of a
wash programme by 3, 6 or 9 hours by press-
ing the "Delay start" button.
You can change or cancel the delayed start
time at any time before you press the "Start/
Pause" button by pressing the "Delay start"
button again (when all indicators are off, the
wash programme will start immediately).
If you have already pressed the "Start/Pause"
button and you want to change or cancel the
delayed start, proceed as follows :
• To cancel the delay start and start the cycle
immediately, press "Start/Pause" and then
6
, you then need to select a
"Delay start". Press "Start/Pause" to start the
cycle.
• To change the timer delay period, you must
go through the "Stop" position
programme your cycle.
The lid will be locked during the delayed start
time. If you need to open it, you must first pause
the appliance by pressing the "Start/Pause"
button. After closing the lid again, press the
"Start/Pause" button.
Start of the programme
Press the "Start/Pause" button to start the cy-
cle. The corresponding light will come on
green. It is normal for the programme selector
to remain stationary during the cycle. The light
corresponding to the current cycle is illumina-
ted.
+ : Prewash + Wash
+ : Rinses + Spin
: End of cycle
The drain pump can operate for a short
time when the appliance fills water.
Interrupting a programme
Adding washing during the first 10 mi-
nutes
Press the "Start/Pause" button : the corre-
sponding light will flash green while the appli-
ance is paused. The lid can only be opened
around 2 minutes after the washing machine
has come to a stop. Press the "Start/Pause"
button again to continue the programme.
Modifying the programme in progress
Before making any changes to the current pro-
gramme, you need to pause the washing ma-
chine by pressing the "Start/Pause" button. If
the modification is not possible, the "Start/
Pause" button flashes red for a few seconds. If
you still decide to change the programme, you
must cancel the current programme (see be-
low).
Cancelling the programme
If you want to cancel the programme, turn the
programme selector to the "Stop" position
End of the programme
The washing machine stops automatically, the
"Start/Pause" button goes out and the light
and re-
.
www.zanussi.com