Wake-On-Lan Support (Wol) - HP Blade dc72 Network Manual

NOTE
specification 2.0 and support Remote Management and Control Protocol (RMCP) based alerts.
ASF 1.0 implementations will not support RMCP due to lack of security in the ASF 1.0
specification. NIC-Based Alerts are enabled and configured by installing the ASF 2.0 agents for
the NIC you are using. These are available at http://www.hp.com. ASF alerts can also be enabled
and configured using the Common Information Model (CIM).

Wake-On-LAN Support (WOL)

To enable or disable Wake-On-LAN from a power off state:
1. Run the Computer Setup utility by pressing F10 at POST.
2. In the Advanced menu, select Device Options > S5 Wake on LAN.
3. Select Disable to prevent WOL from occurring while the computer is in a power off state or
select Enable to allow WOL to occur from a power off state.
NOTE
To enable or disable Wake-On-LAN from a low power state:
Windows XP
1. Select Start > Control Panel.
2. Double-click Network Connections.
3. Double-click Local Area Connection.
4. Click Properties.
5. Click Configure.
6. Click the Power Management tab, then select or clear the check box to Allow this device to bring
the computer out of standby.
Windows 2000
1. Select Start > Settings > Control Panel.
2. Double-click Network and Dial-up Connections.
3. Right-click Local Area Connection.
4. Click Properties.
5. Click Configure.
6. Click the Power Management tab, then select or clear the check box to Allow this device to bring
the computer out of standby.
NOTE
Administrators Guide. The Remote Management Administrators Guide is included with the
Remote Management Setup Utilities and is available on the Support Software CD or at
http://www.hp.com.
ENWW
NICs featuring Alerting Capabilities comply with Alert Standard Format (ASF)
The default state for S5 Wake on LAN is Enable.
For more information on Wake-On-LAN, refer to the Remote Management
Wake-On-LAN Support (WOL) 3