Page 3
Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.
This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
Warranty Standard Warranty Datavideo equipment are guaranteed against any manufacturing defects for one year from the date of purchase. The original purchase invoice or other documentary evidence should be supplied at the time of any request for repair under...
DVD drives, Hard Drive, Solid State Drive, SD Card, USB Thumb Drive, Lighting, Camera module, PCIe Card are covered for 1 year. The three-year warranty must be registered on Datavideo's official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase.
Disposal For EU Customers only - WEEE Marking This symbol on the product or on its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point for the recycling of waste electrical and electronic equipment.
The transmitter allows transmission of up to 4K50/59.94/60 image quality video. With the 56V power connected to one end of the HBT-16 HDBaseT receiver, the HBT-16 will thus be able to power the transmitter by Power over Ethernet (PoE). On the transmitter end (HBT-15), there is also a 12V/30W DC output serving to supply power to backend devices.
HDMI OUT HDMI port for video output. DVIP Port Connects to Ethernet switch or router, serving as a communication port between the network and the HBT-16 receiver. 56V DC IN 56V DC power input connection Power LED Indicator ON: Power connected...
Note: Visit https://hdbaset.org/hdbaset- recommended-cables/ for cable recommendations. RS-232/RS-422 Interface The RS-232/RS-422 port connects HBT-16 directly to Datavideo’s camera controllers such as RMC-180, RMC-300A or RMC-300C. Use the RS-232 or RS-422 custom cable to connect. See RS-232/RS-422 pinout for more information about the respective cabling.
4. RS-232/RS-422 Pinout The camera controller can be connected to the HBT-16 Receiver box through the RS-232 or RS-422 interface using a custom Ethernet cable. The respective connection wiring schemes are shown below. RS-232 HBT-16 Receiver Box Camera Controller White/Orange...
Page 13
RS-422 HBT-16 Receiver Box Camera Controller White/Orange White/Orange Orange Orange White/Green White/Green Blue Blue White/Blue White/Blue Green Green White/Brown White/Brown Brown Brown...
5. Dimensions All measurements in millimeters (mm) 6. Specifications Video / Audio Input HDBaseT RJ-45 x 1 Output HDMI 2.0 x 1 2160p60/59.94/50/30/29.97/25 (4:4:4 8bits) 1080p60/59.94/50/30/29.97/25 Supported 1080i60/59.94/50 Resolutions 720p60/59.94/50 480i59.94 576i50 Control DVIP Ethernet RJ-45 x 1 RS-422 / RS-232 RJ-45 x 1 Power DC IN...
Page 15
Physical and Operating Environments Operating 0 – 40°C (32°F – 104°F) Temperature Storage -20 – 60°C (-4°F – 140°F) Temperature Humidity 10% to 80% (non-condensing) HDBaseT Video transmission at 2160p60/59.94/50 for Transmission Up to 100m using the CAT. 6A Cable (lower Distance resolutions are also supported)
Page 16
Service and Support www.datavideo.com/product/HBT-16 Datavideo Technologies Co., Ltd. All rights reserved 2020 Jan-17.2022 Ver: E1...