Page 3
Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.
This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
Page 5
10. Make sure that the total amperes of all the units that are plugged into a single wall outlet do not exceed 15 amperes. 11. Never push objects of any kind into this unit through the cabinet ventilation slots, as they may touch dangerous voltage points or short out parts that could result in risk of fire or electric shock.
Datavideo office. All non-Datavideo manufactured products (product without Datavideo logo) have only one year warranty from the date of purchase. Damage caused by accident, misuse, unauthorized repairs, sand, grit or water is not covered under warranty.
Drive, Lighting, Camera module, PCIe Card are covered for 1 year. The three-year warranty must be registered on Datavideo's official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase. Disposal...
The receiver accepts up to 4K image quality video. With the 56V power connected to one end of the HBT-12 HDBaseT receiver, the HBT-12 will thus be able to power the transmitting device by PoE plus technology (PoE++). Please only use Cat 7 Ethernet cables to connect PoE++ powered devices.
DVIP Port The DVIP port can be connected to an Ethernet switch or router, serving as a communication port between the network and the HBT-12 receiver. 56V DC IN 56V DC power input connection Power LED Indicator ON: Power connected...
Cable Selection for cable recommendations. RS-232/RS-422 Port (RJ-45) The RS-232/RS-422 port connects HBT-12 directly to Datavideo camera controllers such as RMC-180, RMC-300A or RMC-300C. Use the RS- 232 or RS-422 custom cable to connect. See 232/RS-422 pinout for more information about...
Page 12
DIP Switch The receiver box allows long distance connectivity to PTR-10T MARK II of up to 120 meters while compromising on maximum supported resolution of up to 1080p. Select 4K mode (2160p) if the connection distance is less than 70 meters. If your system is not required to support resolutions higher than 1080p, you can activate long reach mode and enjoy longer cable reach of up to 120 meters.
RMC-180, RMC-300A or RMC-300C. You will need to use a custom Ethernet cable to connect between the controller and HBT-12. Wire the connection cable according to the respective RS- 232 and RS-422 wiring diagrams shown below.
Page 14
RS-422 Remote Controller HBT-12 Receiver Box White/Orange White/Orange Orange Orange White/Green White/Green Blue Blue White/Blue White/Blue Green Green White/Brown White/Brown Brown Brown Remote OUT RS-232/RS-422 Port...
6. Specifications HBT-12 HDBaseT Receiver Box Video / Audio Input HDBaseT RJ-45 x 1 Output HDMI x 1 Control DVIP Ethernet RJ-45 x 1 RS-422 / RS-232 RJ-45 x 1 Power DC IN DC 56 V PoE Standard IEEE 802.3bt...
Page 17
Cable Selection The table below summarizes the recommended Cat 7 cable. Cable Range Video Resolution Ultra HD video formats: HDMI Deep color: 1080p, 60, 48 bpp. 4K x 2K Cat 7 120 meters Data rates higher than 5.3 Gbps or above 255 MHz TMDS clock.