Datavideo HBT-30 Instruction Manual
  1. Manuals
  2. Brands
  3. Datavideo Manuals
  4. Receiver
  5. HBT-30
  6. Instruction manual

Datavideo HBT-30 Instruction Manual

3-channel hdbaset receiver
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
HBT-30

Advertisement

Table of Contents
loading

Related Manuals for Datavideo HBT-30

Summary of Contents for Datavideo HBT-30

  • Page 1 HBT-30...

  • Page 2: Table Of Contents

    Table of Contents TABLE OF CONTENTS ............. 2 FCC COMPLIANCE STATEMENT ........5 WARNINGS AND PRECAUTIONS ........5 WARRANTY ..............7 ............. 7 TANDARD ARRANTY ............ 7 HREE ARRANTY DISPOSAL ..............8 1. INTRODUCTION ............9 EATURES ..............9 2. SYSTEM DIAGRAM........... 10 3.
  • Page 3 5. RS-232/RS-422 PINOUT ........... 25 RS-232 ..............25 RS-422 ..............26 6. FREQUENTLY-ASKED QUESTIONS ......27 7. DIMENSIONS ............28 8. SPECIFICATIONS ............29 SERVICE AND SUPPORT ..........32...
  • Page 4 Disclaimer of Product & Services The information offered in this instruction manual is intended as a guide only. At all times, Datavideo Technologies will try to give correct, complete and suitable information. However, Datavideo Technologies cannot exclude that some information in this manual, from time to time, may not be correct or may be incomplete.

  • Page 5: Fcc Compliance Statement

    This product should only be operated from the type of power source indicated on the marking label of the AC adapter. If you are not sure of the type of power available, consult your Datavideo dealer or your local power company.
  • Page 6 10. Make sure that the total amperes of all the units that are plugged into a single wall outlet do not exceed 15 amperes. 11. Never push objects of any kind into this unit through the cabinet ventilation slots, as they may touch dangerous voltage points or short out parts that could result in risk of fire or electric shock.

  • Page 7: Warranty

    Datavideo office.  All non-Datavideo manufactured products (product without Datavideo logo) have only one year warranty from the date of purchase.  Damage caused by accident, misuse, unauthorized repairs, sand, grit or water is not covered under warranty.

  • Page 8: Disposal

    Drive, Lighting, Camera module, PCIe Card are covered for 1 year.  The three-year warranty must be registered on Datavideo's official website or with your local Datavideo office or one of its authorized distributors within 30 days of purchase. Disposal...

  • Page 9: Introduction

    1. Introduction The HBT-30 is an HDBaseT 3-channel receiver which is typically part of a live production “chain”. It supports 4K50/60 Ultra HD video format up to 100m over a single CAT6A cable. It is equipped with the PoE solution to provide power to these PTZ cameras, thereby solving the problem of lacking power supply in the field in the event of long-distance transmission.

  • Page 10: System Diagram

    2. System Diagram  RS-422 Connection (Connecting to PTC-280 and ShowCast 100 as an example)
  • Page 11  DVIP Connection (Connecting to PTC-280 and ShowCast 100 as an example)

  • Page 12: Connections

    HDMI 2.0 Type A video/audio output interfaces. RS-422/RS-232 Interface(CH1/CH2/CH3) This is the RS-422/RS-232 interface to allow you to connect the HBT-30 to the RS- 232/RS-422 REMOTE interface which is located on the rear panel of the Datavideo ShowCast 100 4K ShowCast Studio for controlling the cameras which are connected to the HBT-30 remotely.
  • Page 13 00: RS-232 DVIP Interface This is the DVIP interface for you to connect the HBT-30 to your Wi-Fi router by using the RJ-45 Ethernet cable. After that, you can connect a switcher with the DVIP interface such as the ShowCast 100 4K ShowCast Studio to the same Wi-Fi router.
  • Page 14 Grounding Terminal When connecting this unit to any other component, make sure that it is properly grounded by connecting this terminal to an appropriate point. When connecting, use the socket and be sure to use wire with a cross-sectional area of at least 1.0 mm...

  • Page 15: Front Panel

    Front Panel Power Switch and POWER LED Indicator Power Switch Please use this power switch to turn on or turn off the power. POWER LED Indicator When the Power Switch is turned on, this Power LED indicator will light up. HDBaseT Link CH1/CH2/CH3 LED Indicator When any of the HDBaseT interfaces for the CH1, CH2 or CH3 is connected to the HDBaseT interface...

  • Page 16: Basic Setup

    4. Basic Setup For the basic setup of the HBT-30, please refer to the steps in the following paragraphs. 4.1 If you use the RS-422 Protocols for Remote Controlling (Take system diagram as an example) 4.1.1 Required Equipment  HBT-30 x 1 ...
  • Page 17 4.1.2 Connection Steps 1. At first, please plug the bundled 56V DC IN adapter in the HBT-30 into the DC IN 56V interface which is located on the rear panel of the HBT-30. 2. Please make sure that power cables of the PTC-280 x 3 and ShowCast 100 x 1 are plugged.
  • Page 18 ShowCast 100. 8. Please use an RJ-45 RS-422 cable to connect from the RS-422/RS- 232 interface which is located on the rear panel of the HBT-30 to the RS-232/RS-422 REMOTE 1 interface which is located on the rear panel of the ShowCast 100.
  • Page 19 19. Please use an HDMI cable (max. 10M) to connect from the HDMI OUT interface which is located on the rear panel of the HBT-30 to the VIDEO IN HDMI 3 interface which is located on the rear panel of...

  • Page 20: If You Use The Dvip Protocol For Remote Controlling

    RJ-45 DVIP Cable x 3  CAT 6A Ethernet cable (Max. 100M) x 3 (The upper limit for the power which is supplied by the HBT-30 for each channel is 65W)  DC 12V male to male power cable x 3 ...
  • Page 21 4.2.2 Connection Steps 1. At first, please plug the bundled 56V DC IN adapter in the HBT-30 into the DC IN 56V interface which is located on the rear panel of the HBT-30. 2. Please make sure that power cables of the PTC-280 x 3 and ShowCast 100 x 1 are plugged.
  • Page 22 12. Please use an HDMI cable (max. 10M) to connect from the HDMI OUT interface which is located on the rear panel of the HBT-30 to the VIDEO IN HDMI 2 interface which is located on the rear panel of the ShowCast 100.
  • Page 23 ShowCast 100. 18. Please use an RJ-45 Ethernet cable to connect from the DVIP interface which is located on the rear panel of the HBT-30 to the RJ- 45 LAN interface which is located on your Wi-Fi router. 19. Please use an RJ-45 Ethernet cable to connect from the DVIP interface which is located on the ShowCast 100 to the RJ-45 LAN interface which is located on your Wi-Fi router.
  • Page 24 ShowCast 100 is replaced by any other switcher. Except for connecting the original HDMI cable from the HDMI OUT interface of the HBT-30 to the HDMI IN interface of your switcher, you also need to connect the RS-422 Ethernet cables...

  • Page 25: Rs-232/Rs-422 Pinout

    5. RS-232/RS-422 Pinout You can use RS-232 or RS-422 control protocol to connect the Datavideo ShowCast 100 4K ShowCast Studio to the HBT-30 3-Channel HDBaseT Receiver to control the PTC-280T camera. You will need to use a custom Ethernet cable to connect between the ShowCast 100 4K ShowCast Studio and HBT-30.
  • Page 26 RS-422 ShowCast 100 HBT-30 Receiver White/ White/ Orange Orange Orange Orange White/ White/ Green Green Blue Blue White/ White/ Blue Blue Green Green White/ White/ Brown Brown Brown Brown RS-232/RS-422 REMOTE RS-422/RS-232...

  • Page 27: Frequently-Asked Questions

    CH1/CH2/CH3 HDBaseT Link LED signal of the HBT- indicators on the front panel of the 30 is transferred HBT-30 are lit or not, it those normally or not. indicators are not lit, there may be an issue with the connection, please check that whether all of the cables are connected correctly or not.

  • Page 28: Dimensions

    7. Dimensions All measurements in millimeters (mm)

  • Page 29: Specifications

    8. Specifications HBT-30 3-Channel HDBaseT Receiver Model Name HBT-30 Product Name 3-Channel HDBaseT Receiver Video/Audio Input HDBaseT (RJ-45) x 3 (with PoE function up to 65W per channel) Video/Audio Output HDMI Type-A x 3 Supported Control RJ-45 x 3 (RS-232/RS-422)
  • Page 30 Humidity 10% to 80% (non-condensing) Dimension (LxWxH) 440 x 125 x 44.5 (mm) Weight 1.8Kg...
  • Page 31 Note...

  • Page 32: Service And Support

    Datavideo Technologies Co., Ltd. All rights reserved 2020 Dec.-23.2021 Ver:E1...

Table of Contents