Section 6: Additional Notes - DSC PC5102-433 Installation Manual

Testing Individual Wireless Keys
To ensure that the PC5102-433 receiver is receiving transmissions from these devices,
use the function keys on the (P)WLS909-433/(P)WLS919-433 at several different locations
in the installation.
5.2 Mount the PC5102-433
When you have tested reception of the PC5102-433 with all the wireless devices (see
section 5.1) and you have a good mounting location, mount the PC5102:
1. Pull the Keybus wires through the hole at the bottom of the back part of the
cabinet.
2. Mount the cabinet securely to the wall using the two 'ears' of the cabinet or using
the two mounting holes inside the cabinet. To use holes inside the cabinet, the
PCB must first be removed. To remove the PCB, release it from the two tabs at the
bottom of the PCB and then lift it out.
Caution: Do not touch the antenna or the coils as this could damage the unit and will
result in improper operation.
Note: If you are not using the 'ears' to mount the cabinet, you can break these off.
Now that your PC5102-433 and wireless devices are mounted and working properly, read
Section 6 for information on potential wireless trouble conditions and battery replacement.

Section 6: Additional Notes

Section 6: Additional Notes Section 6: Additional Notes
Section 6: Additional Notes Section 6: Additional Notes
6.1 Trouble Conditions
The control panel always watches for possible trouble conditions. If a trouble condition
occurs, the keypad "Trouble" light will turn on and the keypad will beep. Press [✱][2] to
display the trouble conditions.
The following trouble conditions apply to the PC5102-433 and/or any enrolled wireless keys.
General System Supervisory - This trouble will be generated if the panel loses
communication with any module connected to the Keybus. The event buffer will
log a detailed description of the event.
Device Low Battery - This trouble is generated when a wireless device exhibits a
low battery condition. Press [7] one, two, or three times to view which devices
are experiencing battery failure. An LED keypad will indicate battery failure
using zone lights 1 to 8.
6.2 Wireless Zone Low Battery Transmission
Within any transmission, the device will indicate the status of the battery. If a battery is low,
the system will indicate a Device Low Battery trouble. The system will delay reporting the
event to the central station for the number of days programmed for Zone Low Battery
Transmission Delay in section [370]. This will prevent unnecessary reporting of the event
if the user has been instructed on how to replace batteries.
Replacing Batteries in Wireless Devices
1. Remove the cover of the device from its back plate.
2. Refer to the battery installation instructions on the installation sheet of each
component. Be sure to note the proper orientation of the batteries as you install them.
3. When the fresh batteries are in place, re-attach the cover to the back plate. The battery
trouble will clear when any button is pressed after the installation of the new
batteries and the device should function normally.
NOTE NOTE NOTE: When batteries in one device need to be replaced, the batteries in all devices
NOTE NOTE
may need to be replaced at the same time.
firealarmresources.com
7