Alamo Bush Hog BH300 Series Operator's Manual page 113

10. Deburr ends of driveline sections and clean
away all chips and filings.
11. Apply multi-purpose grease to inside of outer
driveline section. Assemble driveline and install
on tractor and cutter. Pull on each driveline
section to be sure yokes lock into place. Make
certain driveline shielding is in place and in
good condition.
12. Adjust lower lift arm(s) to level cutter right to
left. Refer to tractor operator's manual for
instructions.
Before operating the Implement, check to make sure the Implement input driveline will not
bottom out or become disengaged. Bottoming out occurs when the inner shaft penetrates
the outer housing until the assembly becomes solid-it can shorten no more. Bottoming out
can cause serious damage to the Tractor PTO by pushing the PTO into the Tractor and
through the support bearings or downward onto the PTO shaft, breaking it off. A broken
driveline can cause personal injury.
BH300 Series 12/21
© 2021 Alamo Group Inc.
OPERATION
(S3PT-18)
Operation Section 4-17