Table of Contents
Advertisement
Gear Box Assembly
Level 1.
Tools required: Grease Gun, Clean rag
Parts required: ECHO
LUBE
®
Lithium Based Grease.
1. Clean dirt from the grease fitting (A).
2. Carefully pump grease in each fitting. DO NOT force grease.
Too much pressure will force grease past seals and cause damage.
Apply 1-2 pumps of grease every 15-25 hours of operation.
3. Wipe excess grease from around grease fitting.
BLADE STIFFENER REMOVE
Level 2.
Tools required: (2) 10 mm Wrenches
Parts Required: None
WARNING
Hedge Clipper blades are very sharp. Wear gloves to protect
hands.
1. Disconnect spark plug wire from spark plug.
2. Hold blade bolt heads (B) under blade assembly. Remove blade
locknuts (C) from top side, turning counterclockwise
3. Remove blade stiffener. Replace if bent or damaged.
NOTE
Locking ability of Hedge Clipper blade nuts will diminish each time
they are removed. Replace blade nuts if threading resistance is not
felt when installing locknuts.
4. Assemble blade stiffener using new blade lock nuts if required.
Tighten blade bolts (B) until snug. Loosen blade bolts 1/2 turn.
Hold blade bolts from turning using 10 mm wrench, and tighten
blade lock nuts (C) with other 10 mm wrench.
TM
14 oz. (P/N 91015) or
/
INSTALL
DANGER
H
C
EDGE
LIPPER
O
'
M
PERATOR
S
A
C
C
B
C
B
21
ANUAL
B
Advertisement
Table of Contents
