Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Setting the Machine for Thicknessing
1. Visit the HSE (Health and Safety Executive) website for the
correct safe operating procedures.
HSE Health and Safety Executive
To operate the machine correctly, it is
recommended to read the HSE (Health and Safety
Executive) website at www.hse.gov.uk. on the safe
operation procedures.
2. Connect a 125mm extraction hose to the extraction hood
outlet.
3. Lower the thicknessing hood and secure in place with the lift
and shift handle, see fig 10-11.
Fig 10-11
Push
4. Release the rise and fall clamping handle (A) and turn
the operating wheel (B) clockwise to raise the thicknessing
table to the required thickness using the 'Digital Display' .
Turn the clamping handle in the locked position to secure
the table, see fig 13-14-15.
Fig 13-14-15
Un-Lock
Digital Display
CONNECT THE MACHINE TO THE MAINS SUPPLY!
5. Make sure the mushroom shaped emergency stop button is
unlocked. Twist the button to unlock,see fig 19.
6. Clear all the tools away from the thicknesser and press the
'GREEN' button on the control assembly to start the machine.
Allow the thicknesser to reach full speed, see fig 16.
Lock
7. Raise the autofeed lever to engage the thicknessing function
and guide the timber through, see fig 17.
8. When you are finished, switch off the machine by pressing
the 'RED' button on the control assembly and wait until the
machine comes to a complete stop. Disengage the autofeed
fuction to reduce wear on the autofeed drive wheel.
14
Fig 16
Advertisement
Table of Contents
