Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
Symbols on the charger
Symbols on the charger
Read all of this manual carefully
Read all of this manual carefully
before using the appliance.
before using the appliance.
#
This tool is double insulated;
This tool is double insulated;
therefore no earth wire is required.
therefore no earth wire is
Always check that the power
required. Always check that the
supply corresponds to the voltage
power supply corresponds to
on the rating plate.
$
the voltage on the rating plate.
The charging base is intended for
The charging base is intended
indoor use only.
for indoor use only.
Warning! Your product is designed for light spills only.
Labels on appliance
Labels on appliance
This appliance can also be used to pick up everyday liquid
u
The following symbols appear on this appliance along with the
The following symbols appear on this appliance along with the
spills. Use the squeegee accessory on non-absorbent,
date code:
date code:
hard surfaces. On absorbent surfaces, such as carpet,
your appliance will pick up wet spills better without the
accessory.
Only use with charger S003AQ 15
Only use with charger S003BD_15 /
For best performance on hard surface wet pickups, insert
SSC-040015XX
S003AQ 15
S003BD_15
u
SSC-040015XX
squeegee into the bowl nozzle opening.
Features
Features
For best results when using this accessory, hold the appli-
u
This tool includes some or all of the following features.
This tool includes some or all of the following features.
ance at an angle of 45° and pull it slowly towards you.
1. On/off switch (press and hold)
1. On/off switch
u
2. Bowl release button
2. Dust bowl
there is any liquid in the bowl, do not turn the unit upside
3. Dust bowl
3. Charger
down, sideways, point the nozzle upward, or shake the
4. Charger
vac excessively.
Fig. A
5. Charging bracket
After picking up liquid substances clean the appliance and
u
Drv pick up cloth filter
6.
Fig. A
not properly cleaned after wet pickups.
Charging the battery (Fig. B, C)
Before charging, be sure to empty all liquid contents and
6. Wet/Dry foam insert
u
Place the charger (3) into the charging port at the rear of
dry thoroughly, to avoid damage to your appliance.
u
7. W
the unit (3a) and plug into the electrical outlet.
Fig. B
Switch the electrical outlet on.
Optimising the suction force
u
8. Squeegee
Use
9. Brush tool
cleared regularly during use.
10. Crevice tool
Before first use, the battery must be charged for at least
u
Emptying and cleaning the product.
10 hours.
Installation
Switching on and off (fig. D)
Warning!
To switch the appliance on, press and hold the on/off
regularly.
The product can be attached to a wall to provide a convenient
u
switch (1).
storage and charging point for the appliance.
Press the bowl release button (2) and pull the dust bowl
u
To switch the appliance off, release on/off switch (1).
(3) straight off.
u
Warning! Never pick up wet applications with these units.
suitable for the wall type and is appropriate to the weight of
While holding the dust bowl over a bin or sink, pull out the
u
the appliance.
Optimising the suction force
Mark the location of the screw holes (within reach of an
To replace the dust bowl, place it back onto the handle
u
u
electrical outlet for charging the vac while it is on the wall
In order to keep the suction force optimised, the filters must
Warning!
bracket).
be cleared regularly during use.
6
G
Place the foam insert (6) into the centre of the wet/dry
u
7
(Original instructions)
(Original instructions)
Fix the mounting bracket to the wall using appropriate
u
screws and plugs for the type of wall and weight of the
Emptying and cleaning the product.
appliance.
Hang the appliance on the wall by placing the opening
u
Removing the dust bowl and filters (fig.E & F).
on the base of the vac over the hooks in the wall mount
Warning! The filters are re-usable and should be cleaned
charging bracket.
regularly.
Rotate the dust bowl (2) anti clockwise and remove from
Assembly
u
the handle of the unit.
While holding the dust bowl over a bin or sink, pull out the
u
filter (4) to empty the contents of the bowl.
These models may be supplied with some of the following
To replace the dust bowl, place it back onto the handle
u
accessories:
and rotate clockwise until it locks firmly into position.
A squeege tool (8) for wet use on hard surfaces.
Warning! Never use the appliance without the filters.
u
Optimum dust collection will only be achieved with clean
A brush tool (9) for furniture and stairs.
u
(Original instructions)
filters.
u
Fitting (Fig. D)
Cleaning the dust bowls and filters
Insert the appropriate accessory into the front of the appli-
u
u
water.
The dust bowls and filters can be washed in
ance. Make sure that the accessory is pushed fully in.
u
warm soapy water.
u
Make sure that the filters and the dust bowl are
Use
u
dry before re-fitting.
u
10 hours.
Place the appliance on the charging bracket whenever it is
Replacing the filters
u
ever worn or damaged.
not in use.
The filters should be replaced every 6 to 9 months and
Warning! Before charging, be sure to empty all liquid contents
whenever worn or damaged.
dealer.
and dry thoroughly, to avoid damage to your appliance.
Replacement filters are available from your BLACK+DECKER
dealer:
Charging the battery (Fig. C)
Maintenance
Make sure that the appliance is switched off. The battery
Maintenance
u
Your BLACK+DECKER corded/cordless appliance/tool has
will not be charged with the on/off switch (1) pressed.
Your BLACK+DECKER corded/cordless appliance/tool has
been designed to operate over a long period of time with a
Place the appliance on the charging bracket (5).
been designed to operate over a long period of time with a
u
minimum of maintenance. Continuous satisfactory operation
Plug in the charger. Switch on at the mains.
minimum of maintenance. Continuous satisfactory operation
u
depends upon proper tool care and regular cleaning.
Leave the appliance to charge for at least 21 hours.
depends upon proper tool care and regular cleaning.
u
Warning! Before performing any maintenance on corded/
While charging, the charger may become warm. This is
Warning! Before performing any maintenance on corded/
cordless power tools:
normal and does not indicate a problem. The appliance can
cordless power tools:
Switch off and unplug the appliance/tool.
u
Switch off and unplug the appliance/tool.
u
Or switch off and remove the battery from the appliance/
Warning! Do not charge the battery at ambient temperatures
u
Or switch off and remove the battery from the appliance/
u
tool if the appliance/tool has a separate battery pack.
below 10 °C or above 40 °C.
tool if the appliance/tool has a separate battery pack.
Or run the battery down completely if it is integral and then
Or run the battery down completely if it is integral and then
u
u
switch off.
switch off.
Unplug the charger before cleaning it. Your charger does
Unplug the charger before cleaning it. Your charger does
To switch the appliance on, press and hold the on/off
u
u
u
not require any maintenance apart from regular cleaning.
not require any maintenance apart from regular cleaning.
switch (1).
Regularly clean the ventilation slots in your appliance/tool/
Regularly clean the ventilation slots in your appliance/tool/
To switch the appliance off, release on/off switch (1).
u
u
u
charger using a soft brush or dry cloth.
charger using a soft brush or dry cloth.
Regularly clean the motor housing using a damp cloth. Do
Regularly clean the motor housing using a damp cloth. Do
u
Wet and dry pick up
u
not use any abrasive or solvent-based cleaner.
not use any abrasive or solvent-based cleaner.
For everyday spills of dry material, use your appliance
u
without the squeegee accessory.
Protecting the environment
Protecting the environment
Z
Separate collection. Products and batteries marked
Separate collection. Products and batteries marked
-
with this symbol must not be disposed of with normal
with this symbol must not be disposed of with normal
household waste.
household waste.
ENGLISH
ENGLISH
10
-
5
Advertisement
Table of Contents
