Remote Control; Installation; Battery Charge - Black & Decker BXVR500E Original Instructions Manual

ENGLISH (Original instructions)

REMOTE CONTROL

(AI) AUTO cleaning mode button
Button Cleaning mode Go Home
(AJ) (returns to the charging station
automatically)
Direction buttons (up / down /
(AK)
right / left)
(AL) Start button or stop
(AM) Button to select the time
(AN) Button to select the schedule
(AP) Edge Cleaning Mode button
(AQ) Button Room cleaning mode
NOTE: Insert 2 AAA batteries* before using the remote
control for the first time. Make sure that the positive and
negative poles are located in the correct direction in the
battery compartment.
*batteries no included
♦ If the model of your appliance does not have the
accessories described above, they can also be bought
separately from the Technical Assistance Service.
IMPORTANT:
Cables or other objects on the ground can hinder the
mobility of the robot. Remove these objects before using
the robot vacuum cleaner.
♦ Use the vacuum cleaner the robot only on short pile
carpets.
♦ Furniture less than 8cm can block the robot. Lift the
furniture if you need to clean this area.
♦ Put a safety barrier on the stairs to prevent it from falling
in case the fall arrest sensors do not work properly.
6

Installation

♦ Be sure to remove all packaging material from inside the
appliance.
Charging base position:
♦ Connect the charger to the charging base.
♦ Place the charging base flat and next to the wall.
♦ To receive a good signal, you must leave a radius of 1m
to the right and left and 3 meters forward of the base.
♦ Connect to adapter to the mains.
♦ If the charging base is removed when works, it will cause
incapability of the appliance to recharge.
♦ Don't move the charging base artificially during the
cleaning

BATTERY CHARGE:

♦ Warning: A new battery does not come with a full charge
and must be fully charged before using the device for
the first time.