HP Designjet cc800ps Reference Manual page 21

quickref.fm Page 17 Monday, February 25, 2002 4:09 PM
Scanning thick media
To return the insertion slot height to its Normal position:
hp designjet copier cc800ps
h - Check the box labeled Adjust for extended media
thickness.
i - Change the value for each of the scanner's cameras.
Normally, only positive values should be used.
j - Make test scans and readjust the values until you are
satisfied that the lines are stitched correctly.
k - Click OK to accept your settings.
l - Repeat steps (d) to (h) until you are satisfied with the
results.
a - Press down on the platen as you push first one slider
and then the other (left and right) towards the sides of
the copier.
b - When the platen is returned to its Normal position, the
message Paper Guide in Extended Position will be
replaced by the Load option: Center or Side.
17