Bosch HGS7282UC Use And Care Manual page 46

Service
Table 12: Oven Troubleshooting Chart
Oven Problem
Oven is not heating
Oven is not cooking evenly
Baking results are not as expected
Food takes longer to cook than expected
Food is overcooked
Convection Bake Results are not as
expected
Oven temperature is too hot or too cold
Oven light is not working properly
Oven light will not turn off
Cannot remove lens cover on light
Oven will not Self-Clean properly
Clock and timer are not working properly
Porcelain chips
"F" and a number appears in display and
control beeps
With a new range there is a strong odor
when oven is turned on
Control does not react when the pad is
touched
English 42
Check circuit breaker or fuse box to your house. Make sure there is proper
electrical power to the oven. Be sure oven temperature has been selected.
Adjust oven calibration if necessary (see "Change the Oven Temperature
Offset" on page 15). Refer to cooking charts for recommended rack posi-
tion.
Refer to cooking charts for recommended rack position. Check "Getting the
Most Out of Your Oven" on page 26 for tips and suggestions. Adjust oven
calibration if necessary (see "Change the Oven Temperature Offset" on
page 15).
The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
"Change the Oven Temperature Offset" on page 15.
The oven is carefully calibrated to provide accurate results. However, the
temperature can be offset if food is consistently too brown or too light. See
"Change the Oven Temperature Offset" on page 15.
If the Automatic Convection Conversion Feature is turned off, the tempera-
ture must be manually reduced by 25°F. If the feature is active, the temper-
ature is automatically adjusted. See "Turn Automatic Convection
Conversion ON or OFF" on page 17 for more information. Refer to cooking
charts and tips for rack positions, cooking times and pan selection. Adjust
oven calibration if necessary. See "Change the Oven Temperature Offset"
on page 15.
The oven thermostat needs adjustment. See Oven Temperature Offset on
page 15.
Replace or reinsert the light bulb if loose or defective. Touching the bulb
with fingers may cause the bulb to burn out.
Check for obstruction in oven door. Check to see if hinge is bent. When the
Sabbath feature is activated, the oven light will stay on or off (as selected
during set-up) during the entire Sabbath mode.
There may be soil build-up around the lens cover. Wipe lens cover area
with a clean dry towel prior to attempting to remove the lens cover.
Allow the oven to cool before running Self-Clean. Always wipe out loose
soils or heavy spillovers before running Self-Clean. If oven is badly soiled,
set oven for a five-hour Self-Clean. See Preparing the Oven to Self-Clean.
Make sure there is electrical power to oven. See Clock and Timer sections.
When oven racks are removed and replaced, always tilt racks upward and
do not force them to avoid chipping the porcelain.
This is a fault code. Press Off to clear the display and stop beeping. Reset
oven if necessary. If fault code remains and beep continues, record fault
code, cancel oven and call authorized service technician.
This is normal with a new range and will disappear after a few uses. Oper-
ating the self-clean cycle will also "burn-off" the smell more quickly.
Be sure that pad is clean. Touch the center of the touchpad. Use the flat
part of your finger.
Possible Causes and
Suggested Solutions