Before Washing For The First Time; Transportation - Bosch WGG454A0ID Instruction Manual And Installation Instructions

Notes
The mains voltage and voltage
■
indicated on the appliance (rating
plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The appliance is only connected to
■
an alternating current via a properly
installed earthed socket.
The mains plug fits the socket.
■
The earthing system is properly
■
installed.
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays this
symbol is used: z.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not bent,
■
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Û Drum Clean programme the first
time without laundry.
Note:
The appliance must have been
■
installed and connected properly.
~ "Positioning and connecting"
on page 12
Never switch on a damaged
■
appliance.
Positioning and connecting
Insert mains plug.
1.
Turn the water tap on.
2.
Close the door. Do not load any
3.
laundry.
Select the Û Drum Clean 90°C
4.
programme.
Open the detergent drawer.
5.
Pour approx. 1 litre of water into
6.
manual dosing compartment.
Add standard detergent to manual
7.
dosing compartment according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
Close the detergent drawer.
8.
Select Start/Pause A.
9.
When the programme ends, turn the
10.
programme selector to Off.
Your appliance is now ready for use.

Transportation

e.g. when moving home
Preparatory work:
Turn off the water tap.
1.
Reduce the water pressure in the
2.
supply hose. ~ Page 44
Drain any residual water.
3.
~ Page 43
Disconnect the appliance from the
4.
mains.
Remove the hoses.
5.
Empty the dispensers.
6.
Caution!
Risk of damage to the appliance
caused by detergent/fabric softener
leaking from the dispensers
Leaking detergent/fabric softener
can prevent the appliance from
working correctly, e.g. due to
damage to the electronics.
Empty the dispensers before
transporting the appliance.
en
19