Electrical Connection; Before Washing For The First Time - Bosch WAN Series Instruction Manual And Installation Instructions

All four appliance feet must stand
firmly on the ground.
Tighten the lock nut against the
3.
housing.
In doing so, hold the foot tight and
do not adjust its height.
The lock nuts on all four appliance
feet must be screwed tightly against
the housing.

Electrical connection

:
Warning
Risk of death!
There is a risk of electric shock if you
touch live components.
Never touch or hold the mains plug
■
with wet hands.
Only pull out the mains cable by the
■
plug and never by the cable, as this
could damage it.
Never unplug the mains plug during
■
operation.
Observe the following information and
ensure that:
Notes
The mains voltage and voltage
■
indicated on the washing machine
(rating plate) are the same.
The connected load and fuse
required are specified on the rating
plate.
The washing machine is only
■
connected to an alternating current
supply via a properly installed
earthed socket.
The mains plug fits the socket.
■
The cable cross-section is adequate.
■
The earthing system is properly
■
installed.
Positioning and connecting
The mains cable is only replaced by
■
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
No multiple plugs/couplings or
■
extension cables are used.
If an earth-leakage circuit breaker is
■
used, only a type which displays the
z symbol is used.
Only this symbol guarantees
compliance with the currently
applicable regulations.
The mains plug can be accessed at
■
all times.
The mains cable is not kinked,
■
squashed, altered or cut through.
The mains cable does not come into
■
contact with heat sources.
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory. To
remove any residues from the product
and to remove water that may be left
over from the test, run the first wash
cycle without any laundry.
The washing machine must be
Note:
correctly installed and connected.
~ Page 11
Check the appliance.
1.
Never use a damaged
Note:
machine. Inform the after-sales
service.
Remove the protective foil from the
2.
worktop and the control panel.
Connect the mains plug.
3.
Turn on the water tap.
4.
Do not load any laundry. Close the
5.
door.
Depending on the model, run the
6.
Limpieza/Limpeza tambor (Drum
or Algodón/Algodão
*
Clean)
(Cottons) 90 °C programme.
Open the detergent drawer.
7.
* depending on the model
en
17