Faults And What To Do About Them - Bosch WGG454A0ID Instruction Manual And Installation Instructions

Display
E:36
alternating with
-10
E:35
alternating with
-10 (Suitable for spe-
cial models)
Other displays

Faults and what to do about them

Faults
Water is leaking from the
appliance.
The door cannot be
opened.
The appliance is not filling
with water.
Detergent/fabric softener
is not being dispensed.
Cause/Remedy
Drain pipe or water drain hose is blocked. Clean the drain pipe and the water
■
drain hose.
Drain pipe or water drain hose is caught or jammed. Ensure that the drain pipe
■
and the water drain hose are not kinked or trapped.
The drain pump is blocked.
■
~ "Drain pump is blocked" on page 43
The drain hose at the siphon is blocked.
■
~ "The drain hose at the siphon is blocked" on page 44
The water drain hose is connected too high. Install the water drain hose at a
■
maximum height of 1 meter.
~ "Hose and cable lengths" on page 15
There is water in the base trough, the appliance is leaking. Turn off the tap. Call
customer services.
Turn the programme selector to Off, wait for five seconds and then switch it on
again. If the display appears again, call customer services.
Cause/Remedy
Attach the drain hose correctly or replace it.
■
Tighten the screw fitting on the supply hose.
■
The temperature in drum is too high to open the door.
■
The safety function is activated. Stop the programme?
■
The water level in drum is too high.
■
Can the door only be opened by the emergency release?
■
~ "Emergency release" on page 45
Programme does not start?
■
Is the tap turned on?
■
Could the filter in the water supply be blocked?
■
~ "Filter in the water supply is blocked" on page 44
Note: If an additional water filter has been installed (depending on the
model), check for contaminants and clean if required ~ separate installa-
tion and cleaning instruction for water filter.
Is the supply hose kinked or trapped?
■
Is the appliance filled with water?
■
Is detergent/fabric softener congealed in the dispenser(s)?
■
Is the Ž i-DOS pump unit blocked? Emptying the
■
dispenser(s)~ Page 39, pour about 50°C water into the dispenser(s). Do
not fill the dispensers above the max. mark, and soaking for about 1 hour,
then empty the dispenser(s) and pour detergent/fabric softener again.
If you cannot rectify the fault yourself, please call customer services.
Faults and what to do about them
en
47