Intelligent dosing system
en
Adjusting the basic dosage
Press and hold Ž i-DOS for approx.
1.
three seconds.
The basic dosage setting is
displayed for one of the dispensers.
Change the setting using: ñ Ready
2.
In
Briefly press Ž i-DOS.
3.
The basic dosage setting is
displayed for the second dispenser.
Change the setting using: ñ Ready
4.
In
Press and hold Ž i-DOS for approx.
5.
three seconds, briefly press any
other selectable button or wait
approx. 10 seconds to exit setting
mode.
Notes
The changes are applied to all
■
programmes in which dosing is
possible.
The changes are saved until the next
■
time they are changed and are
retained even after the appliance has
been switched off.
Filling the dispensers
Notes
See the instructions in chapter
■
~ "Before setting up Ž i-DOS"
on page 36
If w or © flashes, fill the relevant
■
dispenser. ~ Page 36
Fill the dispensers as follows:
Pull out the detergent drawer.
1.
38
Open the dispenser lids.
2.
Pour liquid detergent and fabric
3.
softener into the relevant dispensers.
Notes
– Do not fill the dispensers above
the max. marking.
– See the instructions in chapter
~ "Ž i-DOS Setting the dosage"
on page 37
Close the dispenser lids.
4.
To prevent the detergent
Note:
drying out or drying up, do not leave
the dispenser lids open for a long
period of time.
Push in the detergent drawer.
5.