Table of Contents
Advertisement
6.2
MODIFY THE SET POINT
•
push SET key for at least 3 seconds
•
use the UP or DOWN key to modify the setpoint. In chiller mode it is possible to modify the chiller
set point, in heat pump it is possible to modify the heat pump set point, in std-by it is possible to
modify both the set point.
•
push SET to confirm or wait the timeout (15seconds).
7
KEY FUNCTION
KEY
Push and release
Push once again
Push for 3 seconds
During the programming: push
once
Push when an alarm is showed in
menù ALrM
Push once
Pushing
programming
Push for 1 second during the
programming when the display
visualizes Pr1 or Pr2 or Pr3
Push once
Pushing
programming
Push once
Push once
Push once
Push for 3 seconds
1592022020 iCHILL 100D EVO QRG EN rel. 2.0 23.02.2022
ACTION
once
during
the
once
during
the
FUNCTION
Show chiller set point SetC, heat pump set point
SetH, sanitay water set point SetS
In chiller or heat pump if the Energy saving or the
Dynamic setpoint are enabled it shows the real
setpoint Setr.
Allows to modify the set point
To enter parameter modification or confirm a value
To reset the alarm
To read probes value
To change the group of parameters, to change the
parameter, to change the value of the parameter
1 time shows the Pr2 programming level
2 times shows the Pr3 programming level
To read probes value
To change the group of parameters, to change the
parameter, to change the value of the parameter
To turn ON or turn OFF the controller (in chiller or
heat pump depending from CF59 parameter)
To turn ON or turn OFF the controller (in chiller or
heat pump depending from CF59 parameter)
To enter the function Menu
To set the clock (only for controller with clock on
board)
11/40
Advertisement
Table of Contents
