Related Manuals for Bosch DWK096651B
Summary of Contents for Bosch DWK096651B
- Page 1 DWK096651B Operating and installation instructions Internet: http:/ / www.bos ch-haus geraete.de B os ch Info-Team: de Tel. 01 80/ 5 30 40 50 (E 0,14/ Min. DTAG )
-
Page 3: Description Of Appliance
Operating Instructions Description of appliance Operating modes Light / fan Chimney switches If the air intake is inadequate, there is a risk of poisoning from combustion gases which are drawn back into the room. An air-intake/exhaust-air wall box by itself is no guarantee that the limiting value will not be ex- ceeded. -
Page 4: Safety Instructions
Before using for the first time Important notes: Safety instructions The Instructions for Use apply to several ver- Do not flambé food directly under the extractor sions of this appliance. Accordingly, you may hood. find descriptions of individual features that do Risk of grease filter catching fire due to flames. - Page 5 Operating the extractor hood The most effective method of removing vapours produced during cooking is to: Switch the ventilator ON as soon as you begin cooking. Switch the ventilator OFF a few minutes after you have finished cooking. Function Display Switches the extractor motor It shows the on and off at the latest se-...
- Page 6 Filters and maintenance Unhook the security chain by opening the Grease filters: shackle, then lift the grid upward. Metal-mesh filters are used to trap the grease particles in the cooking vapours. The filter mats are made from noncombustible metal. Caution: �...
-
Page 7: Activated Carbon Filter
Filters and maintenance Activated carbon filter: Replacing the activated carbon filter For neutralizing odours in recirculating mode. Reset of the alarm signal Switch off the hood and the lighting. Caution: Press the E-key until the display is unlit. As the filter becomes more and more saturated with Replacing of the filter grease, there is an increased risk of fire and the... -
Page 8: Cleaning And Care
Cleaning and care Replacing the light bulbs Isolate the extractor hood by pulling out the 1. Switch off the extractor hood and pull out the mains plug or switching off the fuse. mains plug or switch off the electricity supply at When cleaning the grease filters, remove the fuse box. -
Page 9: Installation Instructions
Installation Instructions: Important information Old appliances are not worthless rubbish. Valu- Additional information concerning gas cookers: able raw materials can be reclaimed by recycling old When installing gas hotplates, comply with the appliances. Before disposing of your old appliance, relevant national statutory regulations (e.g. in Ger- render it unusable. -
Page 10: Prior To Installation
Prior to installation Exhaust-air mode ��� ��� ��� ��� The exhaust air is discharged upwards through a ventilation shaft or directly through the outside wall into the open. An air-intake/exhaust-air wall box by itself is no Exhaust air should neither be directed into guarantee that the limiting value will not be ex- a smoke or exhaust flue that is currently used for ceeded. -
Page 11: Electrical Connection
Prior to installation Electrical connection Round pipes: WARNING: THIS APPLIANCE MUST BE We recommend EARTHED Internal diameter: 150 mm (at least 120 mm). IMPORTANT: Fitting a Different Plug: Flat ducts must have an internal crosssection that equates to that of round pipes. The wires in the mains lead are coloured in accord- There should be no sharp bends. -
Page 12: Installation
Electrical connection Installation Ensure that the minimum distance between the Electrical data: hob and the extractor hood is maintained – 400 mm Are to be found on the name plate inside the appli- for the electric or gas hob. ance after removal of the filterframe. 4. - Page 13 Installation Connection in Ducting Version with chimney: When installing the ducting version, connect the All the items named in this procedure are hood to the chimney using either a flexible or rigid included in the recirculation kit. The correspond- pipe ø 150 or 120 mm, the choice of which is left to ing accessory numbers can be found at the end the installer.
-
Page 14: Chimney Assembly
Installation Chimney assembly The chimney cannot be installed in recircu- lation hood with the filter cover. Fasten the angle iron 15 to the hood canopy using the screws 12d provided. �� ��� �� Upper Chimney ��� ����� Slightly widen the two sides of the upper Chim- ney and hook them behind the brackets 7.2.1, making sure that they are well seated. - Page 15 DHZ5455...
- Page 16 Robert Bosch Hausgeräte GmbH 436004609_01 - 090218...