Remaining Running Time Display; Timer Programming; End Of Programme; Automatic Switch Off / Interior Light - Bosch SPS59L12GB Operating Instructions Manual

Remaining running time display

When the programme is selected, the
remaining running time of the programme
is indicated on the digital display )*.
The running time is determined during the
programme by the water temperature, the
number of utensils as well as the degree
of soiling and may vary (depending on the
selected programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the programme
in 1-hour steps up to 24 hours.
– Close the door.
– Switch on ON/OFF switch (.
– Press button X + until the digital
display )* jumps to :
– Press X + or – button until the
displayed time corresponds with your
requirements.
– Press START button h, timer
programming is activated.
– To delete timer programming, press
the X + or – button until )* :
indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value : is indicated on the numerical
display )*.
A utomatic switch off after end of
A u t o m a t i c s w i t c h o f f / i n t e r i o r li g h t
programme or interior light*
* depending on model
To save energy, the dishwasher can be
automatically switched off 1 min or 120
min after the programme ends.
The setting can be selected from :
:
:
.
:
:
is
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button #
– Release both buttons.
– Keep pressing programme button #
To change the setting:
– Press programme button 3.
– Press START button h.
.
Appliance does not
switch off automatically.
The interior light 1"
comes on when the door is opened
irrespective of whether the ON/OFF
switch ( is switched on or off.
When the door is closed the light
is off. If the door is open for longer
than 60 min., the light switches off
automatically. The interior light 1"
is lit only when the set value :
selected.
Appliance switches off after 1 min.
Appliance switches off after 120
min.
and press START button h
until : ... is indicated on the digital
display.
The LED for button # flashes
and the digital display )* displays
the factory setting :
until the value : ... is indicated on the
numerical display )*.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to : .
The set value is saved.
en
to
is
.
has been
17