Rinse Aid; Setting Amount Of Rinse Aid; Switching Off Rinse Aid Refill Indicator - Bosch SPS59L12GB Operating Instructions Manual

- white dishwasher activewater slimline 45 cm »logixx«
Hide thumbs Also See for SPS59L12GB:
Table of Contents

Advertisement

Rinse aid %

As soon as the rinse-aid refill indicator H
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
– Open the dispenser 1j by pressing
and lifting the plate on the cover.
– Carefully pour rinse aid up to the max.
mark in the filler opening.
– Close cover until it clicks shut.
– To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.

Setting amount of rinse aid

The amount of rinse aid can be set from
:
to :
:
to obtain very good drying results
( :
Do not change the amount of rinse aid
unless streaks (select lower setting)
or water stains (select higher setting)
are left on the utensils.
– Close the door.
– Switch on ON/OFF switch (.
– Hold down programme button #
and press START button h
until : ... is indicated on the digital
display.
– Release both buttons.
The LED for button # flashes
and the digital display )* displays
the factory setting :
– Press programme button # until
the factory set value :
on the digital display )*.
To change the setting:
– Press programme button 3.
Each time the button is pressed,
the set value increases by one level;
when the value of :
reached, the display jumps back
to :
– Press START button h.
The set value is saved.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator H is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
– Proceed as described under "Setting
PD[
amount of rinse aid" and set the value
to :
The rinse aid refill indicator H is now
switched off.
. Please set rinse aid on
is already set in factory).
(off).
.
en
.
is indicated
has been
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dishwasher

Table of Contents