ECS L7VTA3 Manual page 42

L7VTA3 V3.1a
AGP Aperture Size (128 MB)
This item defines the size of the aperture if you use an AGP graphics adapter.
The AGP aperture refers to a section of the PCI memory address range used
for graphics memory. We recommend that you leave this item at the default
value.
AGP Mode (4X)
This item allows you to enable or disable the caching of display data for the
processor video memory. Enabling AGP-4X Mode can greatly improve the
display speed. Disable this item if your graphics display card does not support
this feature.
AGP Driving Control (Auto)
This item is used to signal driving current on AGP cards to auto or manual.
Some AGP cards need stronger than normal driving current in order to oper-
ate. We recommend that you set this item to the default.
•
AGP Driving Value: When AGP Driving Control is set to Manual,
use this item to set the AGP current driving value.
AGP Fast Write (Disabled)
This item lets you enable or disable the caching of display data for the video
memory of the processor. Enabling this item can greatly improve the display
speed. Disable this item if your graphics display card does not support this
feature.
AGP Master 1 WS Write (Disabled)
This implements a single delay when writing to the AGP Bus. By default, two-
wait states are used by the system, providing greater stability.
AGP Master 1 WS Read (Disabled)
This implements a single delay when reading to the AGP Bus. By default, two-
wait states are used by the system, allowing for greater stability.
Press <Esc> to return to the Advanced Chipset Features page.
CPU & PCI Bus Control
Scroll to this item and press <Enter> to view the following screen:
CMOS Setup Utility – Copyright (C) 1984 – 2001 Award Software
PCI1 Master 0 WS Write
PCI2 Master 0 WS Write
PCI1 Post Write
PCI2 Post Write
PCI Delay Transaction
↑ ↓ → ← : MoveEnter : Select
F5:Previous Values
CPU & PCI Bridge Control
[Enabled ]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
+/-/PU/PD:Value: F10: Save ESC: Exit
F6:Fail-Safe Defaults
38
Item Help
Menu Level
F1:General Help
F7:Optimized Defaults