ECS L7VTA3 Manual page 10

L7VTA3 V3.1a
Table of Mainboard Components
Label Component
AGP1 Accelerated Graphics Port
ATX1 Power connector
AUDIO1 Front-oriented microphone/line-out port header
BAT1 Three volt realtime clock battery
CASFAN1 Auxiliary case cooling fan
CDIN1 Primary CD-in connector
CDIN2 Secondary CD-in connector
CNR1 Communications Networking Riser slot
CPUFAN1 Cooling fan for CPU
DIM1 ~ DIM3 Three 184-pin DIMM sockets
FDD1 Floppy disk drive connector
IDE 1 Primary IDE channel
IDE 2 Secondary IDE channel
IDE 3 Third IDE channel for ATA 66
IDE 4 Fourth IDE channel for ATA 66
J1 Case open alarm header
JP1 Clear CMOS jumper
JP3 BIOS protection jumper
JP4 CPU frequency selection jumper
LAUDIO1* Front-oriented microphone/line-out port header
1
LED1 Memory module LED
LPANEL1* Connector for case front panel switches and LED indicators
LSIR1* Serial infrared cable header 2
LSJ1* Single-color LED header
LUSB1 Front panel USB headers
PANEL1 Connector for case front panel switches and LED indicators
PCI1 ~ PCI5 Five 32-bit add-in card slots
RAIDLED1 IDE3/IDE4 array controller active LED
SIR1 Serial infrared cable header
SJ1 Single-color LED header
SOCKET 462 Socket A for AMD Athlon processor
SPEAKER1 Speaker connecter
USB2 Front panel USB headers
WOL1 Wake On LAN wakeup connector
WOM1 Wake On Modem wakeup connector
*Reserved for OEM customers only.
This concludes Chapter 1. C hapter 2 explains how to install the mainboard.
1
The red indicator LED1 turns on if your system is still powered, at which time
memory modules cannot be installed or uninstalled.
6