Hoover Platinum Power Max CWKTH012 User Manual page 7

Using the hose and tools
NOTE: The carpet washer should be in the upright position when using the hose and tools; this will
de-activate the SpinScrub brushes and brushbar.
Pour the required
amount of carpet
cleaning solution into
the tank.
Push the hose end and
hose solution connector
into the hose and
solution connection port.
Press the trigger on
the hose to release
solution/water.
NOTE: Use the carpet washer or hose to pick up spills before washing and cleaning the area.
Fill the clean water tank
with warm water
(max 40°C).
Select the SpinScrub or Upholstery tool. Slide the
tool over the tab at the end of the hose until it clicks
into place.
Squeeze the trigger on the forward stroke and
release the trigger on the backward stroke to pick
up water/solution. For a dryer finish, follow with
an additional dry stroke with no trigger pressed.
OPERATION
RINSE WASH
Turn the wash/rinse
dial to 'wash'.
Pull down the accessory
hose connector cover.
Plug into the mains and
press the On/Off button
to switch on.
6