Hoover Platinum Power Max CWKTH012 User Manual page 11

CAUTION: Always unplug the carpet washer before performing any maintenance/troubleshooting checks.
Removing and cleaning the nozzle
Remove both tanks and
tilt the carpet washer
back.
IMPORTANT: If the nozzle is fitted incorrectly, this will cause poor dirty water pick up.
Removing and cleaning the SpinScrub brushes
Lie the carpet washer
on its back exposing
the SpinScrub brushes
and brushbar.
NOTE: Carpets and hard floors should be dry vacuumed thoroughly before washing.
This will help prevent excessive build up of dirt/debris in the nozzle.
Lift the nozzle release
clip and pull the nozzle
forward, separating the
tabs on the nozzle and
carpet washer.
Firmly pull the sides
of the SpinScrub
cover and remove the
SpinScrub brushes.
MAINTENANCE
Rinse the nozzle under
water to remove
dirt/debris.
Using a pair of scissors,
remove any threads or
hair caught around the
brushes. Rinse under
water to remove debris.
To replace the nozzle,
line up the tabs on the
nozzle with the tabs
underneath the front of
the carpet washer.
Push the nozzle down
until it clicks into place.
Line up the spindle and
tabs on the side of the
SpinScrub cover into
carpet washer, push
firmly until it clicks into
place.
10