Hoover Platinum Power Max CWKTH012 User Manual page 6

OPERATION
5
IMPORTANT: Your dirty water tank is fitted with a float. When the dirty water tank is full, or the
floorhead is not in contact with the carpet, the float will shut off the suction on the carpet washer. You will
be able to hear if this has happened as the motor noise on the machine will increase. Once the float is
activated, empty the dirty water tank if full. If the dirty water tank is not full then turn off your machine at
the power switch and wait for the float to settle.
Press the recline pedal
and pull the handle
backwards.
For tough stains press
the boost trigger
together with the
solution trigger to
release more water/
solution mix.
NOTE: For best cleaning results use slow straight parallel strokes. Intermittent dry forward strokes will
increase water pick up. The 'rinse' mode will also work when using the hose.
Squeeze the trigger to
release the solution and
water mix.
RINSE WASH
Turn the wash/rinse dial
to 'rinse'. Only water
is released to remove
solution residue.
For best results apply water/solution
on the forward stroke and release
the trigger on the backward stroke to
pick up water/solution. For a dryer
finish, follow with an additional dry
stroke with no trigger pressed.