Understanding Your Keypad; Icon And Led Keypad Symbols - DSC PowerSeries Neo HS2016-4 User Manual

Chapter 2.0 Understanding Your Keypad

2.0 Understanding Your Keypad

The PowerSeries Neo Alarm System supports a variety of wireless, hardwired and proximity
sensor LCD, LED and Icon keypads. All keypads come equipped with the LED status lights
described in section 1 "Quick Reference". HS2LCD series keypads display system messages on
their LCD screen. HS2ICN series keypads display messages, as described in the following section.
HS2LED series keypads display messages via a series of numbered LEDs, as described in the fol-
lowing section. All keypad versions will have a solid blue LED bar that is always on steady except
when, if enrolled, a proximity tag is presented to and successfully read by the keypad.

2.1 Icon and LED Keypad Symbols

HS2ICN Series
1
5
9
12 7
1. Clock Digits 1, 2
2. : (Colon)
3. Clock Digits 3, 4
4. 1 to 8
5. Memory
6. Bypass
7. Program
8. Away
9. Fire
10. Stay
4
2 3
6
11
8
These two 7 segment clock digits indicate the hour digits when the
local clock is active. Digit 2 is also used to identify the zone num-
ber as the 1 when the zone number is 100 or higher and the OPEN
or ALARM icons are active.
This icon is the hours/minutes divider and will flash once per
second when the local clock is active.
These two 7 segment displays are the minute digits when the local
clock is active. The digits 3 and 4 are used to indicate the zone
number for open zones or alarm in memory. These two digits com-
bined with the clock digit 2, scroll one zone per second from the
lowest number to the highest, when scrolling through zones.
These numbers identify troubles when [*][2] is pressed.
Indicates that there are alarms in memory.
Indicates that there are zones bypassed.
Indicates that the system is in Installer or User's programming, or
that the keypad is busy, and the LED will flash in cadence of
250ms ON and 250ms OFF. If Access Code is required, while
accessing star menus, this LED is ON and solid to indicate that the
code is required.
Indicates that the panel is set in the Away Mode.
Indicates that there are fire and/or CO alarms in memory.
Indicates that the panel is set in the Stay Mode.
HS2LED Series
9
15
7
10
6
- 5 -
5
16
17
14
13