Alarm Test; Keypad Zones; Maintenance - DSC PC2550 Instruction Manual

ALARM TEST

∗
Enter [ ][6][Master Code][8] for a 2 second test of the keypad lights, keypad
sounder and alarm bells.
ENTERING ACCESS CODES SUMMARY:
∗
[ ][5][Master Code]...
[1 to 8] [4 digits] Programs first group of 8 codes
[9] [1 to 8] [4 digits] Programs second group of 8 codes
[9] Returns to first group of 8 codes
[#] exits to the Ready mode
USER FUNCTIONS COMMAND SUMMARY:
∗
[ ][6][Master Code]...
[4] Quick-Arm Enable/Disable
[6] Door Chime Enable/Disable
[8] Bell Test Function

KEYPAD ZONES

There are three zones which can be activated from the keypad. These zones
may or may not be active on your keypads depending on how your installer has
programmed them.
[F] Key: Keypad FIRE zone. Pressing this key for 2 seconds will activate the
keypad fire zone and the bell/siren output will pulse ON and OFF.
This zone is annunciated by the "Fire" light on the keypad.
[A] Key: Keypad AUXILIARY zone. Pressing this key for 2 seconds will
produce a series of beeps on the keypad along with the
transmission. To confirm transmission, the keypad sounder will
beep 6 times.
[P] Key: Keypad PANIC zone. Depending on how your installer programs
the panel, pressing this key for 2 seconds may produce a
completely silent alarm or an audible alarm along with the
transmission. If programmed as audible, the alarm bell will ring.

MAINTENANCE

With normal use, the system requires minimum maintenance. The following
should be observed:
1. Do not wash the keypad with a wet cloth. Light dusting with a barely damp
cloth should remove normal accumulations of dust.
2. The battery/bell test is designed to determine battery condition, however it is
recommended that the stand-by battery be replaced every three years.
3. For other system devices such as smoke detectors, passive infrared,
ultrasonic or microwave motion detectors or glassbreak detectors, consult
the respective manufacturer's literature for testing and maintenance.
firealarmresources.com
9