Install A Ds60 Shelf Into The Rack; Rail Tabs Securing The Rear Of The Enclosure; Securing The Front Of The Enclosure - Dell DD9500 Manual

If the chassis does not slide all the way into the cabinet, you may need to further loosen the screws that hold the rear of the
rails in place, then adjust the rails to allow the tabs to fit into the notches.
Figure 24. Rail tabs securing the rear of the enclosure
2. Once the enclosure is completely seated into the rear tabs, secure the enclosure, tighten the screws (two on each rail) that
secure the rails to the channels.
3. Secure the front of the enclosure to the front vertical channels with four screws (two per side), but do not tighten the
screws until they are all in place.
Figure 25. Securing the front of the enclosure

Install a DS60 shelf into the rack

Complete the following steps to install a DS60 expansion shelf.
CAUTION: If the top of the shelf is installed above 32U high, a ladder is required to replace disk drives in DS60
shelves.
Front
Screw (2)
Screw (2)
CL4655
Rear
CL4728
Install the Disk Shelves in the Rack 29